Greetings. I am experiencing a lockup using the new BusLogic 2.0.15 driver present in the 2.0.36 kernel. 2.0.14 from 2.0.35 works like a champ, and has for many moons. My controller is the BT958UW. The box in question is a PII-266, 128M EDO. The only other cards in the box are a fairly generic SVGA PCI card and a DE500BA NIC (also PCI). At boot, the driver properly detects the host adapter, displays it's information, and then locks hard after "scsi : 1 host." No attached scsi device information is displayed. My BusLogic driver is compiled statically, rather than as a module. The following is boot output from 2.0.14/2.0.35, just so you can see how the host adapter is configured (all settings reported match the settings in AutoSCSI). scsi: ***** BusLogic SCSI Driver Version 2.0.14 of 29 April 1998 ***** scsi: Copyright 1995-1998 by Leonard N. Zubkoff <[EMAIL PROTECTED]> scsi0: Configuring BusLogic Model BT-958 PCI Wide Ultra SCSI Host Adapter scsi0: Firmware Version: 5.07B, I/O Address: 0xEFF4, IRQ Channel: 11/Level scsi0: PCI Bus: 0, Device: 13, Address: 0xFEBFF000, Host Adapter SCSI ID: 7 scsi0: Parity Checking: Enabled, Extended Translation: Enabled scsi0: Synchronous Negotiation: UFFFFFF#FFFFFFFF, Wide Negotiation: Enabled scsi0: Disconnect/Reconnect: Enabled, Tagged Queuing: Enabled scsi0: Scatter/Gather Limit: 128 of 8192 segments, Mailboxes: 211 scsi0: Driver Queue Depth: 211, Host Adapter Queue Depth: 192 scsi0: Tagged Queue Depth: Automatic, Untagged Queue Depth: 3 scsi0: Error Recovery Strategy: Default, SCSI Bus Reset: Enabled scsi0: SCSI Bus Termination: Both Enabled, SCAM: Disabled scsi0: *** BusLogic BT-958 Initialized Successfully *** scsi0 : BusLogic BT-958 scsi : 1 host. Vendor: SEAGATE Model: ST19171W Rev: 0024 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 scsi0: Target 0: Queue Depth 28, Wide Synchronous at 40.0 MB/sec, offset 15 scsi : detected 1 SCSI disk total. SCSI device sda: hdwr sector= 512 bytes. Sectors= 17783112 [8683 MB] [8.7 GB] Partition check: sda: sda1 sda2 sda3 sda4 VFS: Mounted root (ext2 filesystem) readonly. scsi0: Tagged Queuing now active for Target 0 Any ideas? Thanks! -- "I look around me .. and all I see are surfaces .. without depth." - To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [EMAIL PROTECTED]
