[EMAIL PROTECTED] wrote:
>
> Hi,
>
> Ever since 2.2.0pre8, I have not been able to boot the kernel with
> scsi-emulation enable for my hp burner. After the aic7xxx driver (version
> 5.1.10) detects my scsi hard drive, the cdr gets detected and the kernel
> stops booting:
>
> Detected scsi CD-Rom at sr0 at scsi1, channel 0, id 0, lun 0
> SCSI Channel 0:resetting for second half of retries.
> SCSI bus is being reset for host 1 channel 0.
> SCSI: aborting command due to timeout: pid 25, scsi 1, channel 0, id 0,
> lun 1, Request Sense 20 00 00 10 00
> scsi: detected 1 SCSI CD-Rom 1 SCSI Disk total.
> **freezes**
>
> Without scsi emulation, it boots fine, but then I can't burn cd's. Kernel
> 2.0.36 with an older aic7xxx driver (version 5.1.4) boots fine. Is there
> a newer aic7xxx driver that will fix this? Or is it a problem with
> scsi-emulation?
It sounds like a problem in the scsi-emulation code. Did you make sure
that the option "Probe all LUNS" was disabled in the SCSI setup?
--
Doug Ledford <[EMAIL PROTECTED]>
Opinions expressed are my own, but
they should be everybody's.
-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in
the body of a message to [EMAIL PROTECTED]
