Hi , would anyone pls help. I need to make the box work on its own without the use of any external sdcard.
Please note: I am trying to install the uboot on internal MMC there is no nand flash in my device. regards mallah. On Thu, Jan 16, 2014 at 1:44 AM, Rajesh Mallah <mallah.raj...@gmail.com>wrote: > > i am following : > > https://github.com/linux-sunxi/u-boot-sunxi/wiki > > i used sunxi branch and > > make cubietruck ARCH=arm CROSS_COMPILE=arm-linux-gnueabihf- > > dd if=u-boot-sunxi-with-spl.bin of=/dev/mmcblk0 bs=1024 seek=8 > > > U-Boot SPL 2014.01-rc1-09154-geccc92d (Jan 16 2014 - 01:41:18) > Board: Cubietruck > DRAM: 1024 MiB > CPU: 960000000Hz, AXI/AHB/APB: 3/2/2 > Card did not respond to voltage select! > spl: mmc init failed: err - -17 > ### ERROR ### Please RESET the board ### > > > > > > > > On Thu, Jan 16, 2014 at 1:20 AM, Rajesh Mallah <mallah.raj...@gmail.com>wrote: > >> >> >> Hi >> >> i would like to install uboot on the internal MMC card of mele m3 (A20 , >> 1024MB) >> model. could anyone suggest which uboot source and what board config >> should work. >> >> thanks (but sorry if the question was too novice). >> >> regds >> mallah. >> > > -- You received this message because you are subscribed to the Google Groups "linux-sunxi" group. To unsubscribe from this group and stop receiving emails from it, send an email to linux-sunxi+unsubscr...@googlegroups.com. For more options, visit https://groups.google.com/groups/opt_out.