Thanks for the guidance @Hans. 
I'm trying to build Mainline U-Boot <http://linux-sunxi.org/Mainline_U-boot> 
now. 
Will post my progress here.

On Tuesday, May 19, 2015 at 2:56:30 PM UTC+4, sufi al hussaini hassani 
kamili raheemi wrote:
>
> I have a board that's got A20 with Samsung's SDRAM 'K4B1G1646G BCK0'. 
>
> The problem I'm facing now is that I'm not able to get it to boot. I keep 
> getting the following on debug UART:
>
> U-Boot SPL 2014.04-10706-g36080eb (Aug 19 2014 - 16:42:16)
> DRAM:Timeout initialising DRAM
>
> resetting ...
>
> .... (Repeats infinitely)
>
>
> I suspected that the (old) '[dram_para]' in my FEX file was causing this, 
> as it was configured for 'K4B4G1646D' (which is widely used).
> So, I edited the FEX file based on the info I could gather from the 
> SDRAM's datasheet. It now looks like this:
>
>
> [dram_para]
> dram_baseaddr = 0x40000000
> dram_clk = 384
> dram_type = 3
> dram_rank_num = 1
> dram_chip_density = 1024
> dram_io_width = 16
> dram_bus_width = 32
> dram_cas = 9
> dram_zq = 0x7f
> dram_odt_en = 0
> dram_size = 256
> dram_tpr0 = 0x42d899b7
> dram_tpr1 = 0xa090
> dram_tpr2 = 0x22a00
> dram_tpr3 = 0x0
> dram_tpr4 = 0x0
> dram_tpr5 = 0x0
> dram_emr1 = 0x4
> dram_emr2 = 0x10
> dram_emr3 = 0x0
>
> I tried booting with this but to no avail. The problem persists (same 
> error).
>
> I looked for ways to get the DRAM info directly from the hardware and 
> found meminfo in sunxi tools. 
> I was able to compile (and run) it (on a A20 based commercial board), but 
> I just can't figure out how to get it running on my board.
>
> Now, I'm confused- whether just setting the correct values in my FEX would 
> suffice or would I have to rebuild U-Boot.
> I would appreciate if someone could point me in the right direction to 
> solve this problem. 
>
> Thanks.
>

-- 
You received this message because you are subscribed to the Google Groups 
"linux-sunxi" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to linux-sunxi+unsubscr...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

Reply via email to