On Thu, Mar 21, 2002, Maksim Krasnyanskiy <[EMAIL PROTECTED]> wrote: > >His failure scenario sounds like the HC crashed, which would be a bit > >odd looking at the code. Do you get any other error messages around the > >time when the problems start occuring ? > > Here is the log > > - Device works with usb-uhci and zero packet enabled in driver. > > - modprobe -r usb-uhci > > - modprobe uhci > uhci.c: USB UHCI at I/O 0x3440, IRQ 11 > usb.c: new USB bus registered, assigned bus number 1 > hub.c: USB hub found > hub.c: 2 ports detected > hub.c: USB new device connect on bus1/1, assigned device number 2 > > - device initialized (ie bunch of ctrl and intr transfers) > > - bulk out transfer > uhci.c: 3440: host controller process error. something bad happened
This is what I was looking for. > usb.c: USB disconnect on device 2 > hub.c: USB new device connect on bus1/1, assigned device number 3 > usb_control/bulk_msg: timeout > usb.c: USB device not accepting new address=3 (error=-110) > hub.c: USB new device connect on bus1/1, assigned device number 4 > usb_control/bulk_msg: timeout > usb.c: USB device not accepting new address=4 (error=-110) > > - re plug (only once) > hub.c: USB new device connect on bus1/1, assigned device number 5 > usb_control/bulk_msg: timeout > usb.c: USB device not accepting new address=5 (error=-110) > hub.c: USB new device connect on bus1/1, assigned device number 6 > usb_control/bulk_msg: timeout > usb.c: USB device not accepting new address=6 (error=-110) > > - unplug / plug in other device > hub.c: USB new device connect on bus1/1, assigned device number 7 > usb_control/bulk_msg: timeout > usb.c: USB device not accepting new address=7 (error=-110) > hub.c: USB new device connect on bus1/1, assigned device number 8 > usb_control/bulk_msg: timeout > usb.c: USB device not accepting new address=8 (error=-110) > > - modprobe -r uhci; modprobe uhci > Device connected and initialized successfully. What kernel is this? JE _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
