I have three quick questions for USB people.
1.if anybody has tested usb slave mode on mpc823 pls. let me know the setup details like it was tested with which host , at low or high speed and similar relevant stuff or any problems faced.. is there any existing slave driver for that ? 2.I am getting repeated USB RESET events on host side..I feel posible cause can be cable/connectors as i am using both side series A plug for for two identical 823 boards one running host anothe slave , though i am using the prescribed bit to achieve a 1.5k pulldown to make it a usb device. 3.in slave driver all the descriptor data that has to be supplied to host is to be known beforehand from vendor or it has to be retrieved from hardware ? this question I asked because I spent some time in reading about USB but couldn't find explicit answer to this. Best Regards, _________________________________________________________ Click below to visit monsterindia.com and review jobs in India or Abroad http://monsterindia.rediff.com/jobs _______________________________________________________________ Sponsored by: ThinkGeek at http://www.ThinkGeek.com/ _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
