Hi,
I've got my Archos Jukebox Recorder 20Gb working fine on 2.4.17, and
2.4.17 with the EHCI patch using OHCI, UHCI and EHCI interfaces. It seems
you don't need the ISD-200 support in the kernel. Make sure the JB is on
before the kernel detects the usb interfaces, sometimes the JB has
difficulty switching to USB mode if the USB prot is already initialised.
Or, switch the JB on before plugging it in. If I don't Linux seems to get
part way through the USB/SCSI detection process, then decides there's
nothing there!
I get around 11.5 to 12 MB/sec with EHCI, 900 to 1000 kB/sec with OHCI or
UHCI.
Make sure you unmount the disk before halting the system.
Regards,
Andrew
----- Original Message -----
From: "Achim Reckeweg" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Saturday, February 23, 2002 9:43 PM
Subject: [Linux-usb-users] USB Mass Storage detected but usb-uhci errors in
the log
> Hi *,
>
> I tried to use my Archos Jukebox Recorder 20GB with Linux 2.4.17. The
> Archos is a mp3 jukebox which can be used as an usb storage device.
> On Bjorn's Page (who worked on the driver for the older Archos Jukebox
> 6GB) http://bjorn.haxx.se/isd200/ is stated that the newer ISD-300
> chip should work just fine with the standard usb-storage driver.
>
> At the moment I tried to get it to work just using USB 1.1x.
> Unfortunately
> it does not work out of the box :-(
>
> The usb subsystem recognizes the disk but doesn't show up with a
> usable scsi device. Even though the /proc/scsi/scsi knows about the
> disk (see below).
>
> I pasted the logs below. I think the culprit might be the following
> lines.
>
> Feb 20 18:57:00 localhost kernel: usb-uhci.c: interrupt, status 3,
> frame# 1807
> Feb 20 18:57:13 localhost kernel: usb-uhci.c: interrupt, status 3,
> frame# 1920
> Feb 20 18:57:13 localhost kernel: usb-uhci.c: ENXIO 80000e80, flags 0,
> urb c617ea24, burb c617eccc
>
> I have absolutely no clue what the meaning of these statements are.
>
> Any hints anybody?
>
> Thanks Achim
>
> --------------------------------------------------------------------------
-
> cat /proc/bus/usb/devices
>
>
> /var/log/messages on plugin
> Feb 20 18:56:49 localhost kernel: hub.c: USB new device connect on
> bus1/1/1, assigned device number 14
> Feb 20 18:56:49 localhost kernel: usb.c: USB device 14 (vend/prod
> 0x5ab/0x60) is not claimed by any active driver.
> Feb 20 18:56:49 localhost /etc/hotplug/usb.agent: Setup usb-storage for
> USB product 5ab/60/1101
> Feb 20 18:56:50 localhost kernel: SCSI subsystem driver Revision: 1.00
> Feb 20 18:56:50 localhost usbmgr[1115]: vendor:0x5ab product:0x60
> Feb 20 18:56:50 localhost usbmgr[1115]: class:0x8 subclass:0x6
> protocol:0x50
> Feb 20 18:56:50 localhost usbmgr[1115]: USB device isn't matched the
> configuration
> Feb 20 18:56:50 localhost kernel: Initializing USB Mass Storage
> driver...
> Feb 20 18:56:50 localhost kernel: usb.c: registered new driver
> usb-storage
> Feb 20 18:56:50 localhost kernel: scsi0 : SCSI emulation for USB Mass
> Storage devices
> Feb 20 18:57:00 localhost kernel: usb-uhci.c: interrupt, status 3,
> frame# 1807
> Feb 20 18:57:13 localhost kernel: usb-uhci.c: interrupt, status 3,
> frame# 1920
> Feb 20 18:57:13 localhost kernel: Vendor: HITACHI_ Model:
> DK23CA-20 Rev: 00H1
> Feb 20 18:57:13 localhost kernel: Type:
> Direct-Access ANSI SCSI revision: 02
> Feb 20 18:57:13 localhost kernel: USB Mass Storage support registered.
> Feb 20 18:57:13 localhost /etc/hotplug/usb.agent: missing kernel or user
> mode driver usb-storage
> Feb 20 18:57:13 localhost kernel: usb-uhci.c: ENXIO 80000e80, flags 0,
> urb c617ea24, burb c617eccc
>
>
> cat /proc/bus/usb/devices
> T: Bus=01 Lev=01 Prnt=01 Port=00 Cnt=01 Dev#= 9 Spd=12 MxCh= 0
> D: Ver= 2.00 Cls=00(>ifc ) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
> P: Vendor=05ab ProdID=0060 Rev=11.01
> S: Manufacturer=ARCHOS
> S: Product=ARCHOS USB2.0 (P4a)
> S: SerialNumber=wwww.archos.comA
> C:* #Ifs= 1 Cfg#= 2 Atr=c0 MxPwr= 98mA
> I: If#= 0 Alt= 0 #EPs= 3 Cls=08(stor.) Sub=06 Prot=50
> Driver=usb-storage
> E: Ad=01(O) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
> E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl= 0ms
> E: Ad=83(I) Atr=03(Int.) MxPS= 2 Ivl= 32ms
>
>
> /sbin/lsusb
> Bus 001 Device 013: ID 05ab:0060 In-System Design
> Device Descriptor:
> bLength 18
> bDescriptorType 1
> bcdUSB 2.00
> bDeviceClass 0 Interface
> bDeviceSubClass 0
> bDeviceProtocol 0
> bMaxPacketSize0 64
> idVendor 0x05ab In-System Design
> idProduct 0x0060
> bcdDevice 11.01
> iManufacturer 73
> iProduct 90
> iSerial 110
> bNumConfigurations 1
> Configuration Descriptor:
> bLength 9
> bDescriptorType 2
> wTotalLength 39
> bNumInterfaces 1
> bConfigurationValue 2
> iConfiguration 0
> bmAttributes 0xc0
> Self Powered
> MaxPower 98mA
> Interface Descriptor:
> bLength 9
> bDescriptorType 4
> bInterfaceNumber 0
> bAlternateSetting 0
> bNumEndpoints 3
> bInterfaceClass 8 Mass Storage
> bInterfaceSubClass 6 SCSI
> bInterfaceProtocol 80 Bulk (Zip)
> iInterface 0
> Endpoint Descriptor:
> bLength 7
> bDescriptorType 5
> bEndpointAddress 0x01 EP 1 OUT
> bmAttributes 2
> Transfer Type Bulk
> Synch Type none
> wMaxPacketSize 64
> bInterval 0
> Endpoint Descriptor:
> bLength 7
> bDescriptorType 5
> bEndpointAddress 0x82 EP 2 IN
> bmAttributes 2
> Transfer Type Bulk
> Synch Type none
> wMaxPacketSize 64
> bInterval 0
> Endpoint Descriptor:
> bLength 7
> bDescriptorType 5
> bEndpointAddress 0x83 EP 3 IN
> bmAttributes 3
> Transfer Type Interrupt
> Synch Type none
> wMaxPacketSize 2
> bInterval 32
> Language IDs: (length=4)
> 0409 English(US)
>
>
>
> uhura:[achimr]> cat /proc/scsi/usb-storage-0/0
> Host scsi0: usb-storage
> Vendor: ARCHOS
> Product: ARCHOS USB2.0 (P4a)
> Serial Number: WWWW.ARCHOS.COMA
> Protocol: Transparent SCSI
> Transport: Bulk
> GUID: 05ab0060fffffffffff7d96a
> Attached: Yes
>
> uhura:[achimr]> cat /proc/scsi/scsi
> Attached devices:
> Host: scsi0 Channel: 00 Id: 00 Lun: 00
> Vendor: HITACHI_ Model: DK23CA-20 Rev: 00H1
> Type: Direct-Access ANSI SCSI revision: 02
>
>
>
>
> _______________________________________________
> [EMAIL PROTECTED]
> To unsubscribe, use the last form field at:
> https://lists.sourceforge.net/lists/listinfo/linux-usb-users
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users
