Hi Andrew et all, thanks for your reply. I tried your suggestion but no luck so far. It is getting better if the JB is switched on before. But I get no mountable device. I tried it now with USB 1.1 and USB 2.0 (using a PCMCIA card) I used the USB 2 patch for 2.4.18 and also tried 2.4.19-pre2. It doesn't make any difference; see below. The device is recognized. The usb-storage driver is loaded but there is no /dev/sda1 instantiated.
Any clues? ehci-hub.c: GetStatus port 3 status 0x1803 POWER speed=2 CSC CONNECT ehci-hub.c: 05:00.2 port 3 high speed ehci-hub.c: GetStatus port 3 status 0x1005 POWER speed=0 PE CONNECT hub.c: USB new device connect on bus4/3, assigned device number 2 usb.c: USB device 2 (vend/prod 0x5ab/0x60) is not claimed by any active driver. SCSI subsystem driver Revision: 1.00 Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage scsi0 : SCSI emulation for USB Mass Storage devices ehci-q.c: ep 2-in qtd token 800d8d40 --> status -32 hcd.c: giveback urb c5cbde64 status -32 Vendor: HITACHI_ Model: DK23CA-20 Rev: 00H1 Type: Direct-Access ANSI SCSI revision: 02 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 2 USB Mass Storage support registered. Any more hints? Am Son, 2002-02-24 um 18.14 schrieb Andrew Moyns: > > Hi, > I've got my Archos Jukebox Recorder 20Gb working fine on 2.4.17, and > 2.4.17 with the EHCI patch using OHCI, UHCI and EHCI interfaces. It seems > you don't need the ISD-200 support in the kernel. Make sure the JB is on > before the kernel detects the usb interfaces, sometimes the JB has > difficulty switching to USB mode if the USB prot is already initialised. > Or, switch the JB on before plugging it in. If I don't Linux seems to get > part way through the USB/SCSI detection process, then decides there's > nothing there! > > I get around 11.5 to 12 MB/sec with EHCI, 900 to 1000 kB/sec with OHCI or > UHCI. > > Make sure you unmount the disk before halting the system. > > Regards, > Andrew > _______________________________________________ [EMAIL PROTECTED] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-users
