Dear USB-List,

I'm new to USB and I seem to have a Linux prob recognising a USB Key Drive. 
This devise works ok on WinXP; it pops up as a removeable hard drive and I 
can write to it and read it.

When I plug it in on SuSE 8.0 there is a reassuring 'beep' from the system, 
but the device does not show up for mounting. I have looked at many articles 
and FAQs about this but despite the fact that all kernal msgs etc show USB 
and device detected it does NOT show up in fdisk -l 

There should be a /dev/sdx type entry but it is missing.

The modules seem to load ok, they seem to detect the device.

I have appended the relevent lines from boot.log and messages.

Can anyone help me get this working? I would appreciate any help offered!

PeterB

USB Key Drive 128 MB

lsmod shows:
usb-storage        48416        0       
usb-uhci               21988   0  (unused)
usbcore                57184   1  [usb-storage usb-uhci]

In /var/log/boot.msg
<6>usb.c: registered new driver usbdevfs
<6>usb.c: registered new driver hub
<6>usb-uhci.c: $Revision: 1.275 $ time 14:22:59 Mar 27 2002
<6>usb-uhci.c: High bandwidth mode enabled
<6>usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 14
<4>usb-uhci.c: Detected 2 ports
<6>usb.c: new USB bus registered, assigned bus number 1
<6>hub.c: USB hub found
<6>hub.c: 2 ports detected
<6>usb-uhci.c: USB UHCI at I/O 0xd800, IRQ 14
<4>usb-uhci.c: Detected 2 ports
<6>usb.c: new USB bus registered, assigned bus number 2
<6>hub.c: USB hub found
<6>hub.c: 2 ports detected
<6>usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
<6>hub.c: USB new device connect on bus1/1, assigned device number 2
<4>usb.c: USB device 2 (vend/prod 0xaec/0x5010) is not claimed by any active 
driver.

usbdevfs on /proc/bus/usb type usbdevfs (rw)
<notice>/etc/init.d/rc5.d/S07hotplug start
Starting hotplugging services [ net pci usb^G ]
done

In /var/log/messages
Jun 20 22:46:58 linux kernel: Initializing USB Mass Storage driver...
Jun 20 22:46:58 linux kernel: usb.c: registered new driver usb-storage
Jun 20 22:46:58 linux kernel: scsi2 : SCSI emulation for USB Mass Storage 
devices
Jun 20 22:46:58 linux kernel: WARNING: USB Mass Storage data integrity not 
assured
Jun 20 22:46:58 linux kernel: USB Mass Storage device found at 2
Jun 20 22:46:58 linux kernel: USB Mass Storage support registered.

Jun 20 23:10:10 linux kernel: usb.c: USB disconnect on device 2
Jun 20 23:10:10 linux modprobe: modprobe: Can't locate module block-major-11
Jun 20 23:10:11 linux last message repeated 15 times
Jun 20 23:10:11 linux /etc/hotplug/usb.agent[1513]: Can't ignore signal CHLD, 
forcing to default.
Jun 20 23:10:16 linux kernel: hub.c: USB new device connect on bus1/1, 
assigned device number 3
Jun 20 23:10:16 linux kernel: WARNING: USB Mass Storage data integrity not 
assured
Jun 20 23:10:16 linux kernel: USB Mass Storage device found at 3
Jun 20 23:10:17 linux modprobe: modprobe: Can't locate module block-major-11
Jun 20 23:10:17 linux last message repeated 15 times
Jun 20 23:10:18 linux /etc/hotplug/usb.agent[1565]: Can't ignore signal CHLD, 
forcing to default.

hwinfo --usb :
04: USB 106.0: 10600 Disk
  [Created at usb.100]
  Unique ID: B3Fu.o9+kZpz6ig0
  Hardware Class: disk
  Model: "USB Storage Device"
  Vendor: u0aec "?"
  Device: 5010 "?"
  SubVendor: ""
  SubDevice: "USB Storage Device"
  Revision: "1.00"
  Serial ID: "0AEC301000001A00"
  USB GUID: 0aec50100aec301000001a00
  USB Device status: driver active ("usb-storage")
  Speed: 1.5 Mbps
  Attached to: #3 (Hub)




-------------------------------------------------------
Sponsored by:
ThinkGeek at http://www.ThinkGeek.com/
_______________________________________________
[EMAIL PROTECTED]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-users

Reply via email to