On Sun, May 28, 2000 at 01:12:46AM -0400, Russell Steinthal wrote:
> I've been experiencing a repeatable kernel oops using the Handspring
> Visor USB driver and the 2.4.0-test1 kernel. While I assume this
> could go to the usbvisor list, since the oops appears to be coming
> from usbcore, rather than usb-serial, I'm sending the info here---
> feel free to point me there if I picked wrong. :)
This list is just fine (I read them both :)
> Basically, as documented in the Visor driver documentation, the
> device only shows up when the Hotsync button is pressed, and
> disappears when the sync is completed. As soon as the sync completes
> and the driver "disappears," I get the following kernel oops (as
> translated by ksymoops):
Thanks for the ksymoops dump, but I have a few questions:
Does the sync complete successfully?
Is this the first kernel that this problem showed up in, or have you
successfully synced on other kernel versions (and if so, which ones were
they?)
What host controller driver are you using?
Could you send us the output of the kernel messages (dmesg)?
Did you have usb-serial verbous debugging turned on or not? And if not,
could you turn it on, and then give us the output of dmesg?
Sorry for all of the questions, but it really helps out in debugging.
thanks a lot,
greg k-h
greg@(kroah|wirex).com
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
