----- Original Message ----- From: <[EMAIL PROTECTED]> To: <linuxbios@linuxbios.org> Sent: Sunday, September 02, 2007 20:13 Subject: Re: [LinuxBIOS] different versions of the GA-M57SLI-S4 (PLCC vs SPI)
> Quoting Peter Stuge <[EMAIL PROTECTED]>: > > > For 2 I need to put some labels on a super io photo, so let's start > > with 1. For the first iteration, please check: > > > > * which signals are connected straight across between U5 and U9. (I > > suspect SI, SCLK, HOLD#, VCC, GND, WP# and maybe also SO are all > > connected across.) > > Agree! All of them are inter-connected btw the 2 locations. (only CS is > not) are you sure the HOLD pins are connected eg 0 Ohm ? > > > > * what Q4-1, Q5-1, R99-1 and R102-2 connects to on U5, if anything. > > Q4-1 -> U9-CS# this seems to be conected to the unpopulated resistor R89 right? to what is the other pin of this resistor connected ? i would expect ground.. > Q5-1 -> U5-CS# can you find out to which (i think populated) resistor this also connects ? what is the value of this resistor (if you measure measure both 1->2 and 2->1) ? and to what is the other pin of this resistor connected i expect ground ..? > R99-1 -> VCC > R99-2 -> BIOS_WP-1 > R102-2 -> ? (why does it matter?) it might be the write protect option on this board... can you find out if WP# of both chips is connected to some pin of (or around) BIOS_WP ? > > thus spoke my multimeter.. > Florentin > > -- > linuxbios mailing list > linuxbios@linuxbios.org > http://www.linuxbios.org/mailman/listinfo/linuxbios > -- linuxbios mailing list linuxbios@linuxbios.org http://www.linuxbios.org/mailman/listinfo/linuxbios
