Quoting Tom Sylla <[EMAIL PROTECTED]>: > [EMAIL PROTECTED] wrote: >> So, I should just need to clear any parity and serr errors after >> pci_bus_enable_resources() function runs but before the >> pci_dev_enable_resources() function runs. Like this: > > Well, my suggestion was only to try that as a debug tactic. PERR or > SERR set is probably something bad: misconfigured or misbehaving > hardware. I don't know if blindly clearing them at first is the right > solution, especially for all boards. > > It is only an interesting piece of data if that fix works reliably on > your board.
Well I figured out what the problem is. I have a parity error in the PD_STS?Primary Device Status Register 0x06 and can't clear the bit 15. When I try it just goes back to 0x8080. I am supposed to be able to clear this bit by writing a 1 to the bit location. Why won't it let me clear this bit?? Hugh...this is so frustrating...I am so close:-( Thanks - Joe -- linuxbios mailing list [email protected] http://www.linuxbios.org/mailman/listinfo/linuxbios
