On 13.11.2007 19:34, Harald Gutmann wrote: > Am Dienstag, 13. November 2007 16:53:54 schrieb Carl-Daniel Hailfinger: > >> Strange. None of the changes in my patch show up in your superiotool >> output. That either means these registers are special or some part of >> the patch was ineffective or it was not applied. >> > you are right! - it seems that somewhere a mistake happened to me, but i > can't > say exactly where. >
Thanks for retrying manually. > i attached a diff between the superiotool output from new linuxbios with your > patch and the output from superiotool from an older revision of lb. > also a second diff between the new lb version with your patch and the > propritary bios is attached. (superiotool outputs) > Thanks! It seems the patch is almost commit-ready. > flashrom also don't fail any more with the "old" error message, but it seems > to hang on probing for the mx25l4005a: > benchvice flashrom # ./flashrom -m gigabyte:m57sli -V > Calibrating delay loop... 916M loops per second. OK. > Found canidate at: 00000530-00000e44 > Found LinuxBIOS table at 0x00000530. > LinuxBIOS table found at 0x2ac58971e530. > LinuxBIOS header(24) checksum: 5897 table(2324) checksum: 0c99 entries: 14 > Vendor ID: GIGABYTE, part ID: m57sli > Overwritten by command line, vendor ID: gigabyte, part ID: m57sli. > Found chipset "NVIDIA MCP55", enabling flash write... OK. > Found board "GIGABYTE GA-M57SLI-S4": enabling flash write... Serial flash > segment 0xfffe0000-0xffffffff enabled > Serial flash segment 0x000e0000-0x000fffff enabled > Serial flash segment 0xffee0000-0xffefffff disabled > Serial flash segment 0xfff80000-0xfffeffff enabled > LPC write to serial flash enabled > serial flash pin 29 > OK. > Probing for Am29F040B, 512 KB > probe_29f040b: id1 0x7f, id2 0x45 > Probing for Am29LV040B, 512 KB > probe_29f040b: id1 0x7f, id2 0x45 > Probing for Am29F016D, 2048 KB > probe_29f040b: id1 0xff, id2 0xff > Probing for AE49F2008, 256 KB > probe_jedec: id1 0x7f, id2 0x45 > Probing for At29C040A, 512 KB > probe_jedec: id1 0x7f, id2 0x45 > Probing for At29C020, 256 KB > probe_jedec: id1 0x7f, id2 0x45 > Probing for MBM29F400TC, 512 KB > probe_m29f400bt: id1 0x7f, id2 0x4c > Probing for MX29F002, 256 KB > probe_29f002: id1 0x7f, id2 0x45 > Probing for MX25L4005, 512 KB > > at this point nothing more happens. > Can you abort flashrom with Ctrl-C or does the whole machine hang? If the machine does not hang, can you give me an Acked-by: tag? That way I can commit and improve from there. Regards, Carl-Daniel -- linuxbios mailing list linuxbios@linuxbios.org http://www.linuxbios.org/mailman/listinfo/linuxbios
