hi again!
first of all: thanks for all your quick responses! :-)
--On Wednesday, February 07, 2001 01:46:33 PM -0500 [EMAIL PROTECTED] wrote:
>> i do have 2 128MB SDRAM sticks (one single sided and one double sided).
>
> I'm not sure how many variations you have to worry about, but the code
> works with either 1 or 2, single sided 128M dimms. If you put only
> your single sided dimm in and put it in the right socket, and if all
> the other variables happen to be correct, it should work.
well ... then some other variables might be in the wrong state.
i've tried putting the single sided 128M sdram stick in all of the _4_
sockets but none of them seems to work.
i wonder if there is any quick way to get it going for only that very ram
stick ... like booting up with the original bios and then read the values
of all the config registers?
is that possible? and if yes: do you have some tiny program handy wich
would do that job? :)
one other thing: i noticed that there are to different versions of that
crt0.S ... one which i would get by running the config script and one
sitting in the mainboard subdir. which one is better to get started with?
at least the autogenerated code doesn't have the ramtest stuff included ...
so after doing some first tests i switched over to the mainboard specific
source file.
> You might also try working with anyone working on SPD based SDRAM
> config for the 440 type chip sets. That is really what is needed.
>
i'm glad to hear that someone is working on that sdram autoconfig code.
that's good for the long run. but for now i would like to get it up the
'quick and dirty' way ;-)
best regards,
-- matt.
