On 1/7/06, Rony Bill <[EMAIL PROTECTED]> wrote: > > Saumyadeep Paul wrote: > > helo everyone > > > > i have a reliance web conn (Reliance LSP350R), the problem is i just > cant > > get a stable conn in linux n gppp > > First copy your /etc/wvdial.conf file to a safe place. Then edit the > master to exactly what you read below. > > [Modem0] > Modem= /dev/ttyACM0 > Baud= 115200 > SetVolume= 0 > DialCommand=ATDT > Init=ATZ > Init2=AT+CRM=1;$LGPKT=3 > Dial Command = ATDT > FlowControl= Hardware(CRTSCTS) > [Dialer Reliance] > Username = 22XXXXXXXX > Password = 22XXXXXXXX > Phone = #777 > Stupid Mode = 1 > Inherits = Modem0 > > Now simply run this command 'sudo wvdial reliance'. See what results you > get. This is my working file. The GUI ppp has some problems as it tends > to add unnecessary extra init commands. > > Regards, > > Rony. > > hey rony
my wvdial.conf was configured seeing an earlier post regarding the LSP350R and it did work for a day but since that day i've not been able to browse in linux, i tried the command line route today but alas to no avail, it was the same thing the dialer shows connected but the phone goes to dormant mode and then connects again, effectively not allowin to get any work done, i just cant figure out where the problem might be. -- http://mm.ilug-bom.org.in/mailman/listinfo/linuxers
