Thanks Anton,
With the kernel version 2.6.20 I am using Majority of this changes are
hard code values in mpc8313.c
I did already changed this value for my custom board file.
But I am getting the error irrespectively.
Is the relatonship description between USB DR clk and other as mentioned
in your thread is documented in the manual . I could not find it
atleast in mpc8313e user manual.
Regards
Suvidh
Anton Vorontsov wrote:
On Fri, May 23, 2008 at 02:32:22PM -0400, Suvidh Kankariya wrote:
Hi,
I am trying to use the mpc8313e internal usb phy with internal
oscillator frequency of 24 Mz. in host mode on a custom board.
Whenever I plugin any low/fast speed device the device gets detected but
then always get an error
"cannot read descriptor 64 error 71".Also I get address error after that .
Can somebody point me what this error can be related to ?Can it be a
problem with ehci drivers or some configuration. (I get a valid clock
bit set in the status register).
This reminds me: http://patchwork.ozlabs.org/linuxppc/patch?id=17782
Was getting exactly same symptoms.
Try similar changes, should help.
Also can someone point me how I include support for mmc on spi. I am
using kernel 2.6.20 that comes along with mpc8313e bsp.
Any pointers are highly appreciable.
Thanks in advance
Regards
Suvidh
_______________________________________________
Linuxppc-dev mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-dev
