> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] > On Behalf Of Wolfgang Grandegger > Sent: Wednesday, September 17, 2008 5:18 PM > To: linuxppc-dev > Subject: UCC GETH does not work on my MPC8360EA > > Hello, > > I have a wired problems with my MPC8360EA using Linux > 2.6.27-rc6. The UCC GEHT controller works fine with 100/Full > but fails with 1000/Full. > What I see is that the TX done interrupts come (ifconfig's TX > packet counter goes up), but the messages does not show up on > the wire. RX seems to work properly, though. > > Any idea what's going wrong? Does someone got it working with > 1000/Full?
This looks like an old problem that RGMII Tx shouldn't use internal delay while Rx should use. So try to use 'rgmii-rxid' as phy-connection-type in device tree. Also there should have been a fixup in u-boot for this. So update to use latest u-boot might fix your problem. - Leo _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev