Jochen Friedrich wrote: > What needs to be done though is to document this change in > Documentation/powerpc/dts-bindings/fsl/cpm_qe/cpm/i2c.txt.
How about the below? I'll wait for David to comment on the property name and for any suggestions on the documentation below, then I'll submit a new patch. --- linux/Documentation/powerpc/dts-bindings/fsl/cpm_qe/cpm/i2c.txt 11 Oct 2008 02:49:31 -0000 1.1.1.1 +++ linux/Documentation/powerpc/dts-bindings/fsl/cpm_qe/cpm/i2c.txt 31 Oct 2008 21:15:06 -0000 @@ -10,8 +10,12 @@ - #address-cells : Should be one. The cell is the i2c device address with the r/w bit set to zero. - #size-cells : Should be zero. -- clock-frequency : Can be used to set the i2c clock frequency. If - unspecified, a default frequency of 60kHz is being used. +- clock-frequency : Can be used to set the desired i2c clock frequency (in Hz). + If unspecified, a default of 60 kHz is being used. The actual frequency may + be somewhat higher than this value, depending on how the BRG_CLK and dividers + work out. +- clock-filter : boolean; if defined, indicates that this controller + should enable the SCL digital filter. The following two properties are deprecated. They are only used by legacy i2c drivers to find the bus to probe: - linux,i2c-index : Can be used to hard code an i2c bus number. By default, _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev