Hello all, On Wed, Nov 26, 2008 at 7:26 PM, Leon Woestenberg <[EMAIL PROTECTED]> wrote: > On Wed, Nov 26, 2008 at 4:25 PM, Leon Woestenberg > <[EMAIL PROTECTED]> wrote: >> The non-detected end point boot: >> >> pci 0001:80:00.0: scanning behind bridge, config bf8180, pass 0 >> PCI: Scanning bus 0001:81 >> PCI: Fixups for bus 0001:81 >>
Progress on this issue: I found out that re-programming the end point FPGA again *just* after *uboot* read it, and before Linux kernel has started, makes the end point appear properly. Either u-boot leaves the end point in bad state, or the root complex reset also requires an end point reset. (or a third option I could not think of yet). I'll pick this up on ppc and u-boot mailing list with new info, especially with the ppc4xx maintainers. Consider this thread closed. Thanks for ignoring my ranting :-) Regards, -- Leon _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-dev