Timur, is it possible that the PHY adress doesn't match the one specified in the dts ?
regards, Andre Timur Tabi schrieb: > The Freescale MPC8349e-MITX reference board has two TSECs, the second > of which (eth1) is attached to a Vitesse 7385 5-port switch. > > Using the latest U-Boot, Kernel, and device tree, I cannot bring up > eth1. When I try, I get this message: > > [EMAIL PROTECTED] root]# ifconfig eth1 up > 0:01 not found > eth1: Could not attach to PHY > SIOCSIFFLAGS: No such device > > Unfortunately, I don't even know what this means. > > I believe my network configuration is correct. Here's what ifconfig > says about eth1: > > eth1 Link encap:Ethernet HWaddr 00:E0:0C:00:8C:02 > inet addr:192.168.2.141 Bcast:192.168.255.255 Mask:255.255.0.0 > BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 b) TX bytes:0 (0.0 b) > Base address:0x4000 > > eth1 does work in U-boot, so I know it can be made to work (and I know > the 7385's firmware is uploaded), I just don't know what needs to be > done in Linux. > MATRIX VISION GmbH, Talstraße 16, DE-71570 Oppenweiler - Registergericht: Amtsgericht Stuttgart, HRB 271090 Geschäftsführer: Gerhard Thullner, Werner Armingeon, Uwe Furtner _______________________________________________ Linuxppc-dev mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-dev
