Hi All,
I'm using u-boot to boot kernel 2.6.24.2 on a powerpc based board .
I see that after uncompressing the kernel it hangs.
I found a location (System.map) I think corresponds to the __log_buf (my SDRAM
starts at physical address 0 (and u-boot performs -> Load Address: 00000000
Entry Point: 00000000) .
So I just removed the leading C0xxxxxx from the address leaving xxxxxx .
And that's where I looked .
I did see 2 error messages (though they were somewhat corrupt) the first
designated a memory fault and the second a kernel oops at some address.
I looked this address up on System.map and it's somewhere inside prom.c
in of_scan_flat_dt( ) .
I have a few question at this point :
A)Am I looking at the right memory location for __log_buf ?
B)What is printed to the buffer (printk's of what verbose level ?)
C)In a previous kernel version 2.6.14 I don't remember explicitly using a flat
device tree or pointing at such a tree through the bootm command) , but I used
the ARCH=ppc then as opposed to ARCH=powerpc Now .
I see a lot of stuff regarding the need to provide such a data structure upon
booting via bootm .Do I need to explicitly prepare such a data structure and
provide a pointer to it via bootm ?
Might this be the cause for this early hang ?
Best Regards,
Yigal Goldberger.
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@ozlabs.org
https://ozlabs.org/mailman/listinfo/linuxppc-dev
