Dear Feng Kan,
In message <[email protected]> you wrote:
> This adds support for the Designware SATA controller.
>
> Signed-off-by: Feng Kan <[email protected]>
> Signed-off-by: Mark Miesfeld <[email protected]>
> ---
> drivers/ata/Kconfig | 10 +
> drivers/ata/Makefile | 1 +
> drivers/ata/sata_dwc.c | 2053
> ++++++++++++++++++++++++++++++++++++++++++++++++
> 3 files changed, 2064 insertions(+), 0 deletions(-)
> create mode 100644 drivers/ata/sata_dwc.c
...
> +
> +MODULE_LICENSE("GPL");
> +MODULE_AUTHOR("Mark Miesfeld <[email protected]>");
> +MODULE_DESCRIPTION("DesignWare Cores SATA controller low lever driver");
------------------------------------------------------------^^^^^
Guess that's a typo?
Hmm... that's 2000+ lines of code in a single file. Maybe this should
be split?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected]
On a clear disk you can seek forever.
_______________________________________________
Linuxppc-dev mailing list
[email protected]
https://ozlabs.org/mailman/listinfo/linuxppc-dev
