2009/11/30 Grant Likely <grant.lik...@secretlab.ca>:
> On Mon, Nov 30, 2009 at 2:50 AM, Yogesh Chaudhari <mr.yog...@gmail.com> wrote:
>> Hello,
>> I am running linux kernel with rt patch on embedded board
>> based on lite5200 eval board. From linux-2.6.31 release, in which the
>> mdio patch has gone inside, the fec ethernet does not come up on this
>> board. I get the following message at startup:
>> mpc52xx MII bus: probed
>> mdio_bus f0003000: error probing PHY at address 1
>>
>>
>> After the bootup if I try to do a ifconfig I get the message:
>> net eth2: of_phy_connect failed
>>
>>
>> If I change the value of reg in dts file (lite5200.dts) to 0 then this
>> ethernet comes up. However upto this kernel version, this was not
>> required.
>>
>> Ethernet does not come up on board with original lite5200.dts file
>
> Is your board based on the Lite5200 or the Lite5200B? The phys are at
> different addresses on those two revisions of the board. There is a
> different .dts file for each board.
>
>> phy0: ethernet-...@1 {
>> reg = <1>;
>> };
>>
>> Ethernet comes up on board with this change
>> phy0: ethernet-...@1 {
>> reg = <0>;
>> };
>
> Some PHYs treat address 0 as the 'broadcast' address. You need to
> fill in this field (and modify the ethernet-phy@<address> node name)
> to reflect the address that your phy is actually at.
>
> g.
>
I have tried the same with the latest kernel both with and without
rt, but with the same end result. I have checked that the mpc52xx fec
driver was changed from 2.6.31 version but I am not able to point
where this error is coming up from and how changing the reg value in
dts (which is not required till previous versions) is solving this.
_______________________________________________
Linuxppc-dev mailing list
Linuxppc-dev@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/linuxppc-dev
