Guys:
I'm not quite sure where to ask this question, but all my attempts elsewhere have come up short, so... Put simply, I have an MPC5200b platform with a Fujitsu "Lime" GDC, and I'm trying to run Debian squeeze's xorg on it. Actually, I *have* Debian squeeze's xorg running on the platform just fine, with a 2.6.34-rc1 kernel (kernel.org). Problem is, every single diagonal line is very blocky--- not smooth at all. I used to think this was a problem with X's fonts, but now I don't think so because the mouse cursor's diagonal lines also look equally bad. It's almost as if any time the platform tries to draw a diagonal line, truncation/rounding errors are causing it problems in figuring out which pixels to turn on and off. A non-Linux kernel on this hardware, running a non-X GUI, seems to work fine so I think the hardware isn't the problem. Anyone have any suggestions on where to start with this one? Anyone else running a similar configuration with any success? I'm completely lost, and running out of hair *fast*... Thanks! b.g. -- Bill Gatliff b...@billgatliff.com _______________________________________________ Linuxppc-dev mailing list Linuxppc-dev@lists.ozlabs.org https://lists.ozlabs.org/listinfo/linuxppc-dev