Hi, I was reading this post and a question came to my mind. When I try to compile, did I have to copy the EDK driver folder to my Xilinx 2.6 kernel tree and run the cow.tcl script generated by EDK?? Or this is unnecesay??
Grant Likely-2 wrote: > > On 1/9/08, Joachim Meyer <[EMAIL PROTECTED]> wrote: >> Hi >> >> I switched "Xilinx uartlite serieal port support" and "Support for >> console on Xilinxuartlite serialport" on and "8250/16550 and compatible >> serial support" off, in the kernel config. >> Then I removed the things I added in the xparameters.h and compiled >> successfully. >> But I have yet a few Questions: >> >> - What would you recommend to use? UART-Lite or a 16550 serial port. Can >> I get a console running on the RS232 Port of the Board with both >> possibilities? > > if you don't need to change the baud rate at runtime then use the > uartlite. > > Console works on both. > >> >> - Can you recommend anything for my next steps to get an running linux >> (rootfs usw.)? So far I oriented myself on the Klingauf page, but I think >> it is perhaps not the best one because its too old and some things will >> probably not work the way he did it anymore. > > Use either ELDK or buildroot. Personally, I'd like to be using > OpenEmbedded, but I haven't been successful with that yet. > > Cheers, > g. > > -- > Grant Likely, B.Sc., P.Eng. > Secret Lab Technologies Ltd. > _______________________________________________ > Linuxppc-embedded mailing list > Linuxppc-embedded@ozlabs.org > https://ozlabs.org/mailman/listinfo/linuxppc-embedded > > -- View this message in context: http://www.nabble.com/Linux-for-ml310-tp14675554p14808605.html Sent from the linuxppc-embedded mailing list archive at Nabble.com. _______________________________________________ Linuxppc-embedded mailing list Linuxppc-embedded@ozlabs.org https://ozlabs.org/mailman/listinfo/linuxppc-embedded
