On 2015-08-24 13:32, Volker Kuhlmann wrote:
On Mon 24 Aug 2015 12:16:28 NZST +1200, Brady, Mike wrote:
No issues here (also Pacific/Auckland) with any 2.2 release.
Well, mine is a stock 2.2.x install, about 12 months old, upgraded a
few
times to minor point releases. I hacked the php of squid, squidguard
and
ssh (out of necessity, no BUI support), which doesn't affect ntp.
There is nothing unusual in the log, except maybe this warning:
Aug 24 ...: restrict: 'monitor' cannot be disabled while 'limited' is
enabled
After enabling ntpq queries under advanced, ntpd does not sync within a
minute:
# ntpq -c peer -n
remote refid st t when poll reach delay offset
jitter
==============================================================================
103.242.70.5 .INIT. 16 u - 64 0 0.000 0.000
0.000
203.96.152.12 .INIT. 16 u - 64 0 0.000 0.000
0.000
On Linux, restarting (stop, start) ntpd gives the stratum info
immediately, and syncs to these servers in under 5 minutes. pfsense has
done nothing after 15 minutes.
There is a problem here. What could it be?
Thanks,
Volker
Volker
I think that the INIT states indicate that you are not in fact synced.
What does ntpq -n -c peers show?
I would also suggest that you have at least 3 servers configured to sync
against.
Regards
Mike
_______________________________________________
pfSense mailing list
https://lists.pfsense.org/mailman/listinfo/list
Support the project with Gold! https://pfsense.org/gold
