Здравейте. Тези дни реших да направя от една събираща прах Apple машина рутер за вкъщи. До момента за рутер ползвах i386 машина, с която проблеми не съм имал.
Инсталирах OpenBSD, подкарах интерфейсите, настроих DHCP/DNS/etc, уж всичко на 6, но не. Проблемът е, че при по-голям трафик през някой от интерфейсите, въпросния интерфейс timeout-ва и мрежа през него спира да има до рестарт. Машината е Apple PowerMac G3 B&W. Интерфейсите са: * вградения Apple-ски - bm0 * един интелски - fxp0 * един realtek - rl0 За rl0 когато се получи ядрото се оплаква с "watchdog timeout", за другите два с "device timeout". Не успях да накарам google да ми намери решение на проблема, повечето неща, на които попадам, са свързани с конфликти на прекъсвания, но при мен (доколкото виждам) няма такъв проблем: # dmesg [ using 395092 bytes of bsd ELF symbol table ] console out [ATY,Rage128y]console in [keyboard] USB and ADB found, using USB : memaddr 88000000 size 8000000, : consaddr 88000000, : ioaddr 80b20000, size 20000: memtag 8000, iotag 8000: width 640 linebytes 640 height 480 depth 8 Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2008 OpenBSD. All rights reserved. http://www.OpenBSD.org OpenBSD 4.3 (GENERIC) #1670: Wed Mar 12 11:12:33 MDT 2008 [EMAIL PROTECTED]:/usr/src/sys/arch/macppc/compile/GENERIC real mem = 536870912 (512MB) avail mem = 512065536 (488MB) mainbus0 at root: model PowerMac1,1 cpu0 at mainbus0: 750 (Revision 0x8201): 400 MHz: 1MB backside cache mem0 at mainbus0 mpcpcibr0 at mainbus0 pci: grackle, Revision 0x40 pci0 at mpcpcibr0 bus 0 pchb0 at pci0 dev 0 function 0 "Motorola MPC106 PCI" rev 0x40 ppb0 at pci0 dev 13 function 0 "DEC 21154 PCI-PCI" rev 0x02 pci1 at ppb0 bus 1 "TI TSB12LV21 FireWire" rev 0x02 at pci1 dev 0 function 0 not configured pciide0 at pci1 dev 1 function 0 "CMD Technology PCI0646" rev 0x07: DMA, channel 0 configured to native-PCI, channel 1 configured to native-PCI pciide0: using irq 26 for native-PCI interrupt wd0 at pciide0 channel 0 drive 0: <IBM-DHEA-38451> wd0: 16-sector PIO, LBA, 8063MB, 16514064 sectors wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2 pciide0: channel 1 ignored (disabled) rl0 at pci1 dev 2 function 0 "Realtek 8139" rev 0x10: irq 23, address 00:e0:4c:ac:14:0b rlphy0 at rl0 phy 0: RTL internal PHY fxp0 at pci1 dev 3 function 0 "Intel 8255x" rev 0x05, i82558: irq 24, address 00:50:8b:0f:4d:95 inphy0 at fxp0 phy 1: i82555 10/100 PHY, rev. 0 macobio0 at pci1 dev 5 function 0 "Apple Paddington" rev 0x00 macintr0 at macobio0 offset 0x10 mesh0 at macobio0 offset 0x10000 irq 12: 50MHz, SCSI ID 7 scsibus0 at mesh0: 8 targets "escc-legacy" at macobio0 offset 0x12000 not configured zsc0 at macobio0 offset 0x13000: irq 15,16 zstty0 at zsc0 channel 0 zstty1 at zsc0 channel 1 awacs0 at macobio0 offset 0x14000: irq 17,8,9 headphones audio0 at awacs0 "power-mgt" at macobio0 offset 0x0 not configured "fdc" at macobio0 offset 0x15000 not configured adb0 at macobio0 offset 0x16000 irq 18: via-cuda, 0 targets piic0 at adb0 iic0 at piic0 wdc0 at macobio0 offset 0x20000 irq 13: DMA atapiscsi0 at wdc0 channel 0 drive 0 scsibus1 at atapiscsi0: 2 targets cd0 at scsibus1 targ 0 lun 0: <MATSHITA, CD-ROM CR-589, GA0W> SCSI0 5/cdrom removable atapiscsi1 at wdc0 channel 0 drive 1 scsibus2 at atapiscsi1: 2 targets sd0 at scsibus2 targ 0 lun 0: <IOMEGA, ZIP 100, 12.A> SCSI0 0/direct removable sd0: drive offline cd0(wdc0:0:0): using BIOS timings, DMA mode 2 sd0(wdc0:0:1): using BIOS timings bm0 at macobio0 offset 0x11000 irq 42,33: address 00:50:e4:90:38:04 lxtphy0 at bm0 phy 0: LXT970 10/100 PHY, rev. 3 "nvram" at macobio0 offset 0x60000 not configured ohci0 at pci1 dev 6 function 0 "Opti 82C861" rev 0x10: irq 28, version 1.0, legacy support usb0 at ohci0: USB revision 1.0 uhub0 at usb0 "Opti OHCI root hub" rev 1.00/1.00 addr 1 vgafb0 at pci0 dev 16 function 0 "ATI Rage 128 GL" rev 0x00, mmio wsdisplay0 at vgafb0 mux 1: console (std, vt100 emulation) uhidev0 at uhub0 port 2 configuration 1 interface 0 "Silitek USB Keyboard" rev 1.10/2.00 addr 2 uhidev0: iclass 3/1 ukbd0 at uhidev0: 8 modifier keys, 6 key codes wskbd0 at ukbd0: console keyboard, using wsdisplay0 uhidev1 at uhub0 port 2 configuration 1 interface 1 "Silitek USB Keyboard" rev 1.10/2.00 addr 2 uhidev1: iclass 3/0, 2 report ids uhid0 at uhidev1 reportid 1: input=5, output=0, feature=0 uhid1 at uhidev1 reportid 2: input=5, output=0, feature=4 softraid0 at root bootpath: /pci/@d/[EMAIL PROTECTED]/[EMAIL PROTECTED]/[EMAIL PROTECTED]:/bsd root on wd0a swap on wd0b dump on wd0b Всякакви съвети и предположения са добре дошли. Поздрави, -- Alexander Iliev _______________________________________________ Lug-bg mailing list Lug-bg@linux-bulgaria.org http://linux-bulgaria.org/mailman/listinfo/lug-bg