Yep for sure, it’s widely available. Sorry if I misread the prior note; I thought he was looking for the ROM dump. No worries, thx.
Cheers, SB -- Greetings from Steve Baker “Gravity brings me down...” > On Dec 19, 2020, at 9:00 PM, Greg Swallow <gswal...@mchsi.com> wrote: > > Isn't the SR also included in the Rexx known compatible ROMs zip? > > Dec 19, 2020 6:51:52 PM Steve Baker <stevebake...@gmail.com>: > >> Lastly, has this ROM been dumped? If not, I’ll pull it off the PCB and read >> it. > > > Hello again — I posted my chip to the club100 website earlier today, if that > helps > > http://www.club100.org/memfiles/index.php?&direction=0&order=&directory=Steve%20Baker > > Thanks, > SB > > -- > Greetings from Steve Baker > “Gravity brings me down...” > > >>> On Dec 19, 2020, at 8:24 PM, Jeffrey Birt <bir...@soigeneris.com> wrote: >>> >> >> I’ll try the pic again as it seems the first one was too large. >> >> Jeff Birt >> >> From: M100 <m100-boun...@lists.bitchin100.com> On Behalf Of Steve Baker >> Sent: Saturday, December 19, 2020 7:07 PM >> To: m...@bitchin100.com >> Subject: Re: [M100] SuperROM >> >> Another pic, not sure it was attached correctly... >> >> -- >> Greetings from Steve Baker >> “Gravity brings me down...” >> >> >> >> >> On Dec 19, 2020, at 8:00 PM, Greg Swallow <gswal...@mchsi.com> wrote: >> >> No edge for me to grab and my eyes are not good enough to line it up. >> Maybe the attached photos can help. >> >> >> <10081.jpg> >> >> >> Dec 19, 2020 5:47:48 PM Jeffrey Birt <bir...@soigeneris.com>: >> >> SuperROM – >> >> Working on an M100 now that came with a SuperROM that had stuck in the >> socket and the socket managed getting it out. Socket replaced, but I am >> confused as to how the SuperROM (SR) was ever intended to fit properly. >> >> The SR gets stuck as while the Pin1/28 side is held up from the bottom of >> the socket by the pin 1 tab on the SR PCB, the opposite end drops down so >> far that the PCB falls below the bend of the contacts. This lets the >> contacts spring out over the top of the PCB and thus it is stuck. >> >> If I shim up the SR enough to prevent it getting stuck then it pops out very >> easily. It seems to be a very poor design. Perhaps there is some part of >> this one that is missing? I could not find any images on the web that >> clearly showed the SR board to compare to though. >> >> The contact is also really poor, sometimes it will make contact in the >> socket and sometimes not. It may be that the PCB was damaged when it was >> wrestled out. >> >> Lastly, has this ROM been dumped? If not, I’ll pull it off the PCB and read >> it. >> >> Thanks, >> Jeff Birt >> <IMG_9318_sm.jpg>