I tried running your program in my machine. Here is whole video: https://youtu.be/0D18FS9kNYU
I didn't examined logs but execution just stops in line 16 (N118). How did you initialized coordinate sistem? I see no G92 lines at begining... Also in N102 You start with G0 that is rapid move and than you dont say to what coordinate it should go, but you continue with G90, G54 ... I am not sure this is ok but cannot comment G54... regards. On Sat, May 20, 2017 at 6:11 PM, Simon Mali <smal....@gmail.com> wrote: > I have managed to run machinekit with writing to log.txt active. Please > see the attached log.txt file. I have run the machinekit, it was > complaining because jog XHC-HB04 is missing and the I load the g code file > and run it. Printouts stoped at exact point where execution of g code > commands have stoped: > > Issuing EMC_TRAJ_LINEAR_MOVE -- (+220,+176, > +0,21.000000,-21.000000,10.000000,0.000000,0.000000,0. > 000000,0.000000,0.000000,0.000000, +1,250.000000,250.000000,25.000000, > +0, -1,) > > Then I pressed stop executing g-code button and this comes to surface: > > Issuing EMC_TASK_ABORT -- (+503,+12, +23,) > > After that I quit machinekit. > I hope the printouts are of any help to diagnose the problem. > I think I did not compile the whole machinekit software I downloaded the > latest version with sudo apt-get dist-upgrade. Why this is important? > > > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to a topic in the > Google Groups "Machinekit" group. > To unsubscribe from this topic, visit https://groups.google.com/d/ > topic/machinekit/eiNtWf5MEsg/unsubscribe. > To unsubscribe from this group and all its topics, send an email to > machinekit+unsubscr...@googlegroups.com. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to machinekit+unsubscr...@googlegroups.com. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
