> On 31 Dec 2018, at 17:28, mugginsac <muggin...@gmail.com> wrote:
> 
> Bas,
> 
> Thanks that was the problem. I deleted the PRU pins from the "loadrt 
> hal_gpio" statement and added a note to the comment.
> 
> # load low-level drivers (must not include pins used by PRU)
> loadrt hal_bb_gpio output_pins=807,813,819,826,914,913,911 
> input_pins=809,810,814,818
> 
> I also cleaned up the configs to use Xylotex.bbio and deleted that section 
> from setup.sh.
> That fixed this problem.
> So now I guess I should push my Xylotex config file changes to my github 
> account and generate a pull request.

That would be great. Shout out if you run into trouble!

Bas

> Thanks again,
> Alan

-- 
website: http://www.machinekit.io blog: http://blog.machinekit.io github: 
https://github.com/machinekit
--- 
You received this message because you are subscribed to the Google Groups 
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to machinekit+unsubscr...@googlegroups.com.
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.

Reply via email to