Hi. I'm using Mailman v2.0.13 on Red Hat 7.2 and am running about 10
lists on it with no problems. Yesterday I went and created a new list.
I copied the output of newlist and put it into /etc/aliases. I ran
newaliases, doublechecked everything and then sent a test message to the
list. I got this error back:
----- The following addresses had permanent fatal errors -----
"|/usr/local/mailman/mail/wrapper post gwinnett-announce"
(reason: 1)
(expanded from: <[EMAIL PROTECTED]>)
----- Transcript of session follows -----
Mailman error: post got bad listname: gwinnett-announce
554 5.3.0 unknown mailer error 1
I can't figure out why it doesn't see the list. When I run bin/list_lists
my new mailing list is in the output. I can go to the web interface and
configure the mailing list. I just can't seem to send mail to it.
I've run newaliases and restarted sendmail. I've run bin/check_perms and
everything is okay. I've tried setting up another mailing list with the
same results. My other mailing lists still work fine. Any ideas?
--
Matt Perry | matt at primefactor dot com
------------------------------------------------------
Mailman-Users mailing list
[EMAIL PROTECTED]
http://mail.python.org/mailman/listinfo/mailman-users
Mailman FAQ: http://www.python.org/cgi-bin/faqw-mm.py
Searchable Archives: http://www.mail-archive.com/mailman-users%40python.org/
