Perhaps one of our friends on the list from MapInfo could fill us in? I have also wondered about this and would greatly appreciate some clarification.
Thanks, Scott -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Wednesday, July 31, 2002 10:00 AM To: [EMAIL PROTECTED] Subject: RE: MI-L MB: Fastedit on? Hi Tim, When you set fastedit on, the only reason I can think of why MapInfo enables the Save Table button, is to disable the FastEdit again. When you save the table the FastEdit mode is turned off. Actually there is no edit to be saved because they have allready been saved to the table, this is what the FastEdit mode enables. So when you push the Save Table and "save" the table with the FastEdit mode turned on, the only thing that actually happens is that the FastEdit Mode is turned off for this table. Closing the table without "saving" it doesn't result in lost data, because the changes have allready be made in the table. I'm not quite sure whether this does explaine the behaviour fully, but it might give you a better understanding of the FastEdit mode. Peter ---------------------------------------------------------------------------- -------------------- Peter Horsbøll Møller, GIS Udviklingskonsulent / GIS-Developer Kampsax A/S - GIS Software & Solutions Rugaardsvej 55, 5000 Odense, DK tel: +45 6313 5013, dir:+45 6313 5008, fax: +45 6313 5090 mailto:[EMAIL PROTECTED] www.kampsax-gis.dk and www.kampsax.dk Authorized MapInfo Partner & Distributor in Denmark and Norway. ---------------------------------------------------------------------------- -------------------- Se mere om Dansk MapInfo Brugerkonference på http://www.kampsax-gis.dk/Default.asp?ID=296 Klik ind på http://www.kortal.dk og se det hele lidt fra oven! Check http://www.kortal.dk and have a look at Denmark from above! ----- Videresendt af Peter Møller/Kampsax - 31-07-2002 15:53 ----- "Tim.Nuteson" <Tim.Nuteson@t Til: [EMAIL PROTECTED] arget.com> cc: Vedr.: MI-L MB: Fastedit on? 30-07-2002 17:57 I have "Fastedit On" set for a table, yet as soon as edits are made the Save button on the toolbar lights up. When I click on the Save button, the FastEdited table is listed as one that needs saving. If I instead just close the table WITHOUT saving it, I am not prompted to save it. 1. If Fastedit is ON, why does MI Pro think the table has unsaved edits (i.e. the Save button lights)? 2. If the Save button is lit, why am I allowed to close the table without being prompted to save it? Can anyone explain this? Using MI Pro 6.5. Thanks Tim Nuteson Target Corporation --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 2282