If I do these two selections in Mapinfo Pro: select * from States where stabbr = "WY" into WyomingState select * from Cities where obj within (select obj from WyomingState) into WyomingCities
It works just fine. I end up with a table of WyomingCities I can map, browse, etc. When I save the workspace, however, only the first of the two select statements is saved. When I load the workspace, it comes up with no sign of the WyomingCities table. Is this normal, works-as-designed behavior? Can anyone explain this? I'm using Mapinfo Pro 6.5 Thanks- Tim Nuteson Target Corporation --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 4043