Thank you for your suggestion. Mu-Tien
On Wed, Feb 2, 2011 at 3:49 PM, avadh patel <[email protected]> wrote: > Due to some complications in QEMU's emulation model sometimes the > '-startrip' does not work accurately. You can try to adjust the RIP address > to start of the function or try some nearby rip addresses. > > - Avadh > > On Wed, Feb 2, 2011 at 1:35 PM, Mu-Tien Chang <[email protected]> wrote: > >> I want to switch from emulation mode to simulation mode at a given rip and >> run 200M instructions, but failed to do so. This is my qemu configuration >> line: >> (qemu) simconfig -startrip 4197728 -startlogrip 4197728 -stopinsns 200M >> where 4197728 is in decimal, a converted number from a hex address. >> However, MARSS never did the switching, and ran emulation mode till >> completion. I also tried adding "-run" to the above configuration line, but >> MARSS switched to simulation mode right after I assign "-run". I wonder what >> is the proper way to use "-startrip". Is there a good way to fast forward in >> emulation mode to a given rip or instruction count then switch to simulation >> mode? Thank you. >> >> Mu-Tien >> >> _______________________________________________ >> http://www.marss86.org >> Marss86-Devel mailing list >> [email protected] >> https://www.cs.binghamton.edu/mailman/listinfo/marss86-devel >> >> >
_______________________________________________ http://www.marss86.org Marss86-Devel mailing list [email protected] https://www.cs.binghamton.edu/mailman/listinfo/marss86-devel
