Hi chris the VN V8 rad fitted with few mods it was perfect in width as it
just fitted between the rails It is a little high but still clears the
bonnet. I have made little alloy brackets to keep it in place up top the
bottom just has the standard rubber with a peg that locates on the two holes
I drilled in the rails.I fitted new tanks to mine as I wanted it to be a
single pass not duel pass radiator plus the inlet had to be changed from
drivers side top to passenger side top.Hope this helps unsure how you would
go in a 1600. I didnt have to chop any of my original rad support out only
for the intercooler plumbing
cheers Andrew
FJ MAN wrote:
> what mods did you have to do to fit a vn v8 radiator
> id like to fit one but all measurements seem to suggest no way so im
> guessing theres more room in the 1200 bay or mods were made i see its
> slightly above the radiator support panel yet on a 1600 its a good few
> centrimetres over
> ah well any advise is appreciated :)
> regards chris
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
