Thanks Errol. So there is no difference between the Z18 N/A and Z18ET valve settings. And that distance is between the valve top and actuater not the cam.
-----Original Message-----
From: E Smith [SMTP:[EMAIL PROTECTED]]
Sent: 30/11/2001 13:06
To: [EMAIL PROTECTED]
Subject: RE: Z18ET Valve Clearances.
ADAM,
It says 0.012" �inlet and exhaust hot, �for Z16, Z18, Z20 and Z24 in the Nissan Z series workshop manual.
�
Cheers,
Feral Errol
<mailto:[EMAIL PROTECTED]>
<http://www.datrats.com.au/>
�
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Rowe, Adam
Sent: Friday, 30 November 2001 1:46 PM
To: [EMAIL PROTECTED]
Subject: RE: Z18ET Valve Clearances.
�
Don't they have a different cam design and geometry?� I thought these would effect the measurements.� As they also have different timing chain lengths.� But the numbers still sound right.
-----Original Message-----
From:�� Terry Rudd [SMTP:[EMAIL PROTECTED]]
Sent:�� 30/11/2001 10:26
To:���� [EMAIL PROTECTED]
Subject:������� RE: Z18ET Valve Clearances.
Adam,
�
AFAIK Z's are�the same as most L's
�
Hot
In 0.25 mm (0.010")
Ex 0.30 mm (0.012")
�
Cold
In 0.20 mm (0.008")
Ex 0.25 mm (0.010")
�
regards
Terry
-----Original Message-----
From: [EMAIL PROTECTED] [ <mailto:[EMAIL PROTECTED]>]On Behalf Of Rowe, Adam
Sent: Friday, 30 November 2001 9:56 AM
To: ozdat
Subject: Z18ET Valve Clearances.
Does anyone know the valve clearances for a stock Z18ET?
Adam Rowe
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
