RE: Z series stuff again

[E Smith]

Block heights are from crank centres (L14, L16, L18, Z16, Z18 =207.85 mm) (L20B, Z20, Z22 =227.45mm)    (Z24 =247 mm)   Cheers, Feral Errol mailto:[EMAIL PROTECTED] http://www.datrats.com.au/   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of David Costello Sent: Sunday, 2 December 2001 11:50 PM To: [EMAIL PROTECTED] Subject: Z series stuff again   is there any physical size difference in the Z20 and Z24 blocks?   will the Z24 block bolt onto the same mounts as a Z18?   I was just considering just using a whole Z24 bottom end instead of going to all the trouble of putting the Z24 crank in the Z20 block, trying to weigh up pro's and cons   Dave --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------