Re: Z series stuff again

[mark krawczuk]

hi,  they will work , but it depends on  what crank, rod  etc, combonation  u are using. in my l20  with z24 crank, i am using  1 mm oversize Z20 pistons. the gudgeon pin to crown height is closer than a  l20b piston. i am using the z20 pistons  due to the extra stroke of the crank. if u use the z20 and put in the l20 pistons , they will stick out the block. like i said depends on what conrod , crank combo u end up using.  mark k .----- Original Message ----- From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Monday, December 03, 2001 9:51 AM Subject: Re: Z series stuff again Will pistons intended for an L20B work in a Z20S? I'm converting a Z20S into an L series and have been offered some high comp cosworth pistons but they are for an L20B. I was under the impression that Z20S motors have longer rods...is that true?   Cheers, Eddie Rattley England [EMAIL PROTECTED] www.ratdat.com --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------