RE: turbo intake seal problem

[Geordie Smith]

In Sydney, You can get straight lengths of dunlop hose in most sizes from Graham's Rubber in Granville. It's about $40 a metre and sold in metre lengths.   I might have a bit left if you only need a few inches, what inside diameter do you need?   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of David Costello Sent: Sunday, 20 January 2002 10:58 AM To: Ozdat Mailing List Subject: turbo intake seal problem the piece of rubber that goes around the compressor outlet on the turbo then the intake piping clamps onto on my Z18 has deteriorated over time and now has a huge split in it, as such I'm only holding 4psi tops   where can I get a replacement rubber bit for this, I was going to just try some radiator house or something, but after removal and inspection of old piece, it appears to be a different diametre at either end, so I'm assuming you need a special piece?   Thanks again Dave --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------