Hi All,
I`m about to fit R31 rear disks to my 1600, i have various bits from the
wreckers but not sure what i need to reconnect the handbrake. I also have the
original calliper brackets. My questions are;
1, What parts do i need to
connect the handbrake?
[Terry Rudd] Both rear cables which you'll have to modify
i.e. shorten or get the made up ones from Sydney refer Iggy's post. The rear
cables on the R31 are not designed real well and get dirt and water etc into
them so they are in demand at wreckers, if you get them from a Upull, make
sure they aren't frozen - the angle of the calliper sits on a 1600 much better
(higher towards 12 o'clock high) and doesn't get the water/muck
problem.
2, I`m assuming i need to cut
a section out of the bracket(as seen in photo`s), is this correct?
[Terry Rudd] No, don't do
it. Take a bit longer and grind/sculpture the lip off so the bracket fits over
the A arm flush with the hub and ream out the centre hole in the brackets
until it fits over the flange (it's 2 or 3 mm). Remove the axles (pain I know)
but I cringe every time I see the Craig way on this
one.
3, Do i need different flex
hoses?
[Terry
Rudd] No, R31 flexi hoses are perfect to connect to the 1600 existing
solid lines (straight screw in as same fitting as the 1600 rw
cyls)
4, And where can i buy the stub axel
nuts from and how much would they be?
[Terry Rudd] Nissan genuine part only, refer
Iggy's post again for part number etc.
Much
appreicated,
Kris.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
