Cheers Tony excellent idea, I"ll talk to the engine man and see how big the
pistons are that he want's to put in and take it from there.
Craig
----- Original Message -----
From: "Tony Bryant" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Sunday, September 01, 2002 10:38 PM
Subject: Re: How Much?
> On Sun, 01 Sep 2002 22:10, you wrote:
> > Hey list, how much is the biggest anyone has bored the L18 'W' block out
> > to? I'm not sure who it was but one of you guys was talking about a
factory
> > rally motor based on the L18, that was out to 1900cc?. This week the
> > machining starts, so please reply ASAP.
>
> Dunno about the L18W block, but my old model L20B block went to 87.5mm
> without a problem.
>
> Best bet is to take it to Specialist Engine Services (somehow associated
with
> FlightLine??) at the Ardmore airfield here in Papakura, and pay them about
> $60 to do an ultrasonic cylinder wall thickness test.
>
> They recommended mine was offset bored by 0.050" to give the maximum
average
> wall thickness.
>
> Less than the price of a gasket kit.....
>
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
