'Found that hour or so ago; wrong faucet.  Mine's called "Waterfall"; 'bout
20 years old; not currently shown on the site.  Thanks.

Wilton

----- Original Message -----
From: "E M" <[EMAIL PROTECTED]>
To: "Mercedes Discussion List" <mercedes@okiebenz.com>
Sent: Monday, November 24, 2008 7:20 PM
Subject: Re: [MBZ] OT - kitchen sink faucet


> Not sure if this helps Wilton.
>
>
http://www.deltafaucet.com/customersupport/troubleshoot/kitchen-single-handl
e.html
>
> Ed
> 300E
>
> 2008/11/24 Rolf <[EMAIL PROTECTED]>
>
> > Take a picture, usually these things are all loosened from underneath
> > and then you take it apart via allen socket or so. Home depot and Lowes
> > sell repair "kits" that are pretty generic.
> >
> > -Rolf
> >
> > Redghost wrote:
> > > Not sure if this helps, but I have tried to do repair on kitchen sink
> > > swivel faucets.  I ended up just getting a new faucet and putting that
> > > in.  I had to remove the faucet anyway and there was so much more
> > > needing attention that it was simpler to install new than take the
> > > thing apart and try to find some shop with the old parts still in
stock
> > >
> > > clay
> > >
> > > On Nov 24, 2008, at 1:38 PM, Wilton Strickland wrote:
> > >
> > >> Yea, I know, this is an MB list, but there's lot's of other expertise
> > >> amongst you guys, too.
> > >>
> > >> Any of you guys installed or repaired a swiveling kitchen sink faucet
> > >> recently.  Swiveling spout at our kitchen sink leaks around its base,
> > >> at the
> > >> swivel seal(s), that is.  The spout rises vertically 8 to 10 inches
> > >> above
> > >> the sink then makes a right turn out over the sink.  I think it's a
> > >> Delta
> > >> faucet; can't remember for sure; I installed it 20 years ago.  The
> > >> swiveling
> > >> spout has a ring plate about 3/16 inch tall around its base;
immediately
> > >> above that is a cone-shaped collar nearly 2 inches tall inside of
> > >> which the
> > >> spout swivels.  Any of you fine gentlemen know if the ring and collar
> > >> screw
> > >> off to allow access to seal(s) (probably 0-ring) near the base of the
> > >> spout?
> > >> I wrapped masking tape around the ring and collar to protect finish a
> > >> little
> > >> while ago and tried to unscrew them, probably too timidly thus far -
no
> > >> success.  I THINK they screw on.  Anybody on the list know?
> > >>
> > >> BTW, I AM reasonably well-experienced with plumbing matters - 'just
> > >> can't
> > >> remember 'zackly how to access this spout, and don't wanta "mess up"
the
> > >> finish.
> > >>
> > >> Wilton
> > >>
> > >>
> > >> _______________________________________
> > >> http://www.okiebenz.com
> > >> For new parts see official list sponsor: http://www.buymbparts.com/
> > >> For used parts email [EMAIL PROTECTED]
> > >>
> > >> To Unsubscribe or change delivery options go to:
> > >> http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
> > >
> > >
> > > _______________________________________
> > > http://www.okiebenz.com
> > > For new parts see official list sponsor: http://www.buymbparts.com/
> > > For used parts email [EMAIL PROTECTED]
> > >
> > > To Unsubscribe or change delivery options go to:
> > > http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
> >
> >
> > _______________________________________
> > http://www.okiebenz.com
> > For new parts see official list sponsor: http://www.buymbparts.com/
> > For used parts email [EMAIL PROTECTED]
> >
> > To Unsubscribe or change delivery options go to:
> > http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
> >
> _______________________________________
> http://www.okiebenz.com
> For new parts see official list sponsor: http://www.buymbparts.com/
> For used parts email [EMAIL PROTECTED]
>
> To Unsubscribe or change delivery options go to:
> http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com


_______________________________________
http://www.okiebenz.com
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts email [EMAIL PROTECTED]

To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com

Reply via email to