I have one of those too, it works fine except you need to refill it from
those butane cans for lighters, which can get a little pricey.
--R
MG wrote:
I have this one and like it a lot for small heating jobs like gouging
out holes in foam. It will probably burn the paint around the bolt way
before it gets hot enough to loosen it.
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=42099
Wilton if you have access 3/8 drive air gun and a good tight 6 side
socket you might try that. Rattle it back and forth a few times while
pushing down as hard as you can and it might come loose. Then again it
might wring it off if the gun is good and strong. The idea is that the
vibrations should help loosen the bolt rather then the strength of the
gun.
Manfred
From: "Rick Knoble" <[email protected]>
Subject: Re: [MBZ] OT - JD mower belt challenge
From: "WILTON" <[email protected]>
> Now, if I could get a little bitty torch ----.
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=66050&xcamp=google&utm_source=googlebase&utm_medium=cpc&zmam=33951326&zmas=12&zmac=112&zmap=66050
http://screwdriver.net/tag/butane-torch/
I might have to get that one from Harbor Freight myself.
Rick
190DT
300CD
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
