Unless you use shielding gas you will be unhappy with your results. I promise!
Sent from my iPhone > On Jun 5, 2015, at 4:33 PM, clay via Mercedes <mercedes@okiebenz.com> wrote: > > The wire is garbage, but it came free with the welder. May as well burn > through it. > > setting up feed speed is hit and miss for now. It does not want to feed as > slowly as the graph inside says I need it. There are two amperage speeds. > Lots and not that much. I could not get much speed or heat to get a good bead > > clay > > On Jun 5, 2015, at 1:12 PM, fmiser via Mercedes wrote: > >>> clay wrote: >>> >>> I could not get a decent bead using the PC carcasses and was >>> getting a bunch of blow through. >> >> Thin sheet metal and gasless wirefeed is pretty tough. Set >> the wire feed and amperage low. And get some good wire. The >> HF wire is junk. >> >> >> _______________________________________ >> http://www.okiebenz.com >> >> To search list archives http://www.okiebenz.com/archive/ >> >> To Unsubscribe or change delivery options go to: >> http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com