I've finally gotten to the point where I'm moving the tranny from the bad engine to the new engine --
In removing the steel tranny cooler lines, I found that the clamps that hold them along the oil pan seem to have been clamped around the lines. There is no evidence of a rubber sleeve or anything else between the lines and the clamp. One of them is starting to wear into the line. Is this SOP for MB? I'm thinking of wrapping the steel line with Teflon pipe sealing tape (lots of it), or a strip cut out of a plastic bottle, or ??? Any suggestions or thoughts on the matter? -- OK Don, KD5NRO Norman, OK '90 300D 243K, Rattled '87 300SDL 290K, Limo Lite, or blue car '81 240D 173K, Gramps, or yellow car '78 450SLC 67K, brown car '97 Ply Grand Voyager 78K Van Go