Someone has gone before you. Your bell housing casting is broken because someone has used the “ribs” as a fulcrum for a screwdriver against those little raised “tabs” you can see on the torque converter.
That works, too, when ring gear teeth can’t be accessed. -D > On Apr 18, 2019, at 1:22 PM, Craig via Mercedes <mercedes@okiebenz.com> wrote: > > On Sat, 13 Apr 2019 19:57:42 -0400 Dan Penoff via Mercedes > <mercedes@okiebenz.com> wrote: > >> Or…. >> >> Long flat bladed screwdriver. You can engage the screwdriver blade in >> the flywheel teeth through the cast “screen” in the bottom of the >> flywheel housing and turn the engine over slowly, about a inch or two >> at a time. I’ve done it this way in the past without any negative >> effects. > > Well, amongst everything else I have going on, I went do just that and > found what is shown in the attached picture. > > No flywheel teeth visible => this method won't work. > > > Craig > <bell.housing.jpg> > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com