good luck on getting the caliber working
--FT
On 5/20/19 3:17 PM, Dan--- via Mercedes wrote:
I’m going to run a screw into it just so it seals and I can move the car around
without worrying about loosing break petal.
-D
On May 20, 2019, at 2:53 PM, Rick Knoble via Mercedes <mercedes@okiebenz.com>
wrote:
I have successfully removed bleeder screws by heating with a mapp gas torch,
and quenching with cold water, repeating the cycle several times. If the brake
hose is in close proximity, I wrap it with a wet rag.
Rick
From: mercedes@okiebenz.com
Sent: May 20, 2019 1:41 PM
To: mercedes@okiebenz.com
Reply-to: mercedes@okiebenz.com
Cc: d...@penoff.com
Subject: Re: [MBZ] ML500 Marthamania!
Point well taken, but with the beater approach I’m not putting anything on this
it doesn’t absolutely need to operate.
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
--
--FT
_______________________________________
http://www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com