Hi,
I am using Freescale I.MX6Q SABRE SD board with revisions SCH-27516 rev C2,
700-27516 rev A. I downloaded the Yocto 1.6(daisy) for Freescale BSP using the
following instructions by https://community.freescale.com/docs/DOC-1616.
I added the flexcan node in the file: imx6dl-sabresd.dts. following the
instructions provided in
https://www.mail-archive.com/[email protected]/thrd3.html
---
&flexcan1 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_flexcan1_1>;
status = "okay";
};
---
Now the can-node is available in the dev-tree:
---
root <at> imx6qsabresd:~# dmesg | grep can
vcan: Virtual CAN interface driver
flexcan 2090000.can: device registered (reg_base=c09d8000, irq=142)
can: controller area network core (rev 20120528 abi 9)
can: raw protocol (rev 20120528)
can: broadcast manager protocol (rev 20120528 t)
can: netlink gateway (rev 20130117) max_hops=1
flexcan 2090000.can can0: writing ctrl=0x07292005
---
I interfaced Freescale I.MX 6Q Sabre sd board(CAN_H & CAN_L) and Vector
CANcase XL log. When i do cansend the bus state goes off. I checked the
termination resistor between CAN_H & CAN_L which is 60 ohm. Please, suggest us
to bring up the can device.
Thanks & Regards,
Paventhan K
L&T Technology Services Ltd
www.LntTechservices.com<http://www.lnttechservices.com/>
This Email may contain confidential or privileged information for the intended
recipient (s). If you are not the intended recipient, please do not use or
disseminate the information, notify the sender and delete it from your system.
--
_______________________________________________
meta-freescale mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-freescale
