Hi Daiane,
I have already enabled flexcan by applying a patch to
imx6q-sabresd.dts file. I am able to get the flexcan driver up and configure
it. I am not understanding why does the bus state goes off even when the imx6q
sabresd board's can transreceiver(TJA 1040T) is connected to the vector can. It
would be very helpful even if you tell me how I can go about debugging it. I
have tried using a DSO to check if I can see the transmission signal on TX. But
when I connect the probe to CAN_H and CAN_L of the transreceiver I see
nothing. I have also noticed that the "stby pin" of the transreceiver always
remains high(3.5V). Will I have to apply any patch to somehow make it low and
then run the transreceiver in normal mode instead of standby mode?
With regards,
Paventhan.K
L&T Technology Services Ltd
www.LntTechservices.com<http://www.lnttechservices.com/>
This Email may contain confidential or privileged information for the intended
recipient (s). If you are not the intended recipient, please do not use or
disseminate the information, notify the sender and delete it from your system.
--
_______________________________________________
meta-freescale mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-freescale
