Just a general question that will seem pretty simple to all of the smartcam gurus in here. In a mold cavity, I've got a .50 wide x .40 deep about .50 long runner that ramps up at about a 30 degree angle to the gate. I was wondering just the basic steps to model this up with advanced production milling.Toolpath generation should be no problem if only I could get it drawn right. Any insight would be greatly appreciated. Thanks
__________________________________________________ Do You Yahoo!? Talk to your friends online with Yahoo! Messenger. http://im.yahoo.com ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
